Results 1 to 1 of 1

Thread: I'm the founder and I'm blocked out of my channel. Help!

  1. #1
    Rizon Staff guuchan's Avatar
    Join Date
    Jul 2008
    Posts
    1,532

    Default I'm the founder and I'm blocked out of my channel. Help!

    You can first try this command if you are not banned from the channel:

    Code:
    /msg chanserv clear #channel modes
    If you are still not able to join, you can try the commands below according to the error messages in bold:

    #channel unable to join channel (invite only)

    Code:
    /msg chanserv invite #channel
    #channel unable to join channel (need correct key)

    Code:
    /msg chanserv getkey #channel
    You will get a message from chanserv similar to the one below:

    Code:
    -ChanServ- KEY #channel this_is_the_key
    You can then join the channel by using the following command:

    Code:
    /join #channel this_is_the_key
    #channel unable to join channel (channel is full)

    Code:
    /msg chanserv set #channel mlock -l
    Note: this command will remove your previous locked modes.

    #channel Cannot join channel (SSL is required)

    Code:
    /msg chanserv set #channel mlock -S
    Note: this command will remove your previous locked modes.

    #channel unable to join channel (address is banned)

    Code:
    /msg chanserv unban #channel
    This one can get a little tricky if someone in your channel runs a bot/script to replace the ban automatically after chanserv removing it. If the error message persists, you can use the following command to check who is replacing the ban:

    Code:
    /msg chanserv checkban #channel
    You will get a message from chanserv similar to the one below:

    Code:
    -ChanServ- The ban nick!ident@yourhost.com set by some_nick prevents you from joining #channel.
    You can then either choose to talk to some_nick, or remove his op/halfop access.
    Last edited by guuchan; 08-08-2010 at 12:34 AM.

Similar Threads

  1. Channel dropping loophole [aka: Frozen Channel]
    By Kendra in forum Suggestions
    Replies: 1
    Last Post: 07-12-2010, 05:05 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •